Код ошибки
Модераторы: mihey[nwo], Sponsor, Mr.BOSS, TER
-
А_лександр
- Впервые

- Сообщения: 1
- Зарегистрирован: 15 май 2008, 20:51
Код ошибки
OOB 2000 Y22XE. На диагностике комп выдал ошибку по АКПП - Р1781-неизвестный дефект. Может быть, кто подскажет, что это такое. Спасибо
-
dimaest
- Модератор

- Сообщения: 3134
- Зарегистрирован: 24 дек 2006, 20:11
- Откуда: таллин
- Контактная информация:
для коробки GS8.21 это ошибка по КАНу:CAN Receives Error ....
говорит вот что:
The control unit receives the following signal not or wrong:
Actual engine torque
Above condition must be fulfilled for at least 1 s .
Concerned Terminals:
49, 50
Добавлено спустя 1 минуту 24 секунды:
Work Order Description
Verify programming of the control unit:
Refer to Simtec 71, Y 22 XE Table B-18 PROGRAMMING T03 Program CAN Configuration
If a defect has been found in previous test steps, the following test can be skipped (follow result "YES").
Refer to Table C-07 CAN-Bus Communication Circuit
After successful test/fault repair proceed to the next test step
говорит вот что:
The control unit receives the following signal not or wrong:
Actual engine torque
Above condition must be fulfilled for at least 1 s .
Concerned Terminals:
49, 50
Добавлено спустя 1 минуту 24 секунды:
Work Order Description
Verify programming of the control unit:
Refer to Simtec 71, Y 22 XE Table B-18 PROGRAMMING T03 Program CAN Configuration
If a defect has been found in previous test steps, the following test can be skipped (follow result "YES").
Refer to Table C-07 CAN-Bus Communication Circuit
After successful test/fault repair proceed to the next test step
чем больше в армии дубов - тем крепче наша оборона